andydavy

So some   ****head has stepped board my boat in the marina and "procurred" my landing net. Cant seem to find anywhere in stock with the wsb or seatech nets. Can anyone help?

must have been 

All sorted. Had to switch off the sonarchart live setting

Thats what I dont understand. It's not in routes or tracks. Not sure if it's something to do with interaction with depth sounder?

The relief shading is absolutely brilliant. Amazing accuracy and detail.

Hi I'm running the navionics app on android.

I seem to have a track showing on the chart that I can't delete. It doesnt show in the tracks list.

Anyone know what I can do to get rid of it?

Had exactly the same boat and engine. If you are getting 24kts at about 5000rpm you are trimmed nicely. Mine needed very little trim GPSguru right at about 3%

We used to use yellow plastic gas pipe on our commercial boats

Nice piece of stainless steel

Would love to but can't find anyone to do it. Any ideas?

Brass casing cracked on flange

It's the ammer that means i have to buy a new one!

You were right - now I have to rebuild it!

Does any one know how to remove the raw water pump from the nanni t4.155 (4.380) engine. Mine is leaking from the rear seals. Does it just pull off after removing the two bolts?

I always email then I have a track of whats been said. If dealer / broker can't be bothered then neither can I. When looking last year two sellers lost my potential custom due to their brokers lack of ability to answer me. When I tracked down the sellers both were horrified.

Ended up buying a boat miles away from an absolute brilliant broker who could not have been more helpful.

How long ago was it bought from the dealer?

2006/7 I think

careful with pirate - only the later ones have self draining decks

Hi have a propprotector. Easy to fit and slide on ones quite cheap.

How good is it - I hope to never have to find out!!

The thru hull B744 will not work with new chartplotter and it's so old no adapter cables are available. New ones are upwards of £400 and the old one will be an absolute pig to remove as they are bonded into the fairing.

I'm going to try a Vexilar SP200 from the states as it will run on navionics app which I already have, May have to do as JDP suggests until next time boat comes out of water.

The woes of old electronics - nothing is compatible and you end up having to start again!

Boat currently has a b744 transducer which has been fitted through outer and inner skins! Trying to avoid pulling boat out of water. so it may need to be a cut through outer skin - ouch

I have a 2008 Beneteau Antares7 with nanni 155hp engine.

I want to install a new transducer that shoots through the hull by bonding inside the boat. However the boat is double skinned. Does anyone know where there is an area in the boat that is NOT double skinned - or an easy way to do this??

Thanks in advance

Andy

All sold thank you

@KennyPowers If this is the merc 60hp there is a known problem with the powerhead gasket / grommet disintegrating. Make sure when it's repaired that they use the updated merc kit as below.

"That'll be the grommet closed up where the water pipe meets the adaptor plate. It's a common problem, we've done 2 this week. Mercury have a re work kit to solve it!

You'll need a 32-897971A01 water tube/seal kit, 27-892320001 adapter plate gasket, 27-892319001 powerhead gasket, 10-4007455 bolt, as it usually snaps when you remove it. £164.45 incl vat!!!!!!"

What engine is it?