Jump to content

Saintly Fish

Admin
  • Posts

    8,182
  • Joined

  • Last visited

  • Days Won

    265

Everything posted by Saintly Fish

  1. Shot, imagine trying to cut the eye off that sucka
  2. Ok I’ll double check. I did use all new washers and gaskets though.
  3. Well I’m pretty sure I did yeah. Like I say, maybe there was/is a small air bubble that releases the air then pulls in the extra fluid from the tank. Whenever I remove the pressure cap the level is exactly the same just the level in the tank has dropped.
  4. How about a paravein? Would a weighted one give you some stability in the water to enable a controlled drop??
  5. That’s fair. Not like you. Your Ginge
  6. Cello tape it onto the back of a drone?
  7. Always wondered how you would rig a muscle. They are very wet and stringy.
  8. So apart from..... squid, cuttle, mackerel, sand eels, rainbow trout etc.... what other fish baits you can get from the fishmongers are good dead baits?
  9. Don’t start, we’ve done a good job keeping your sexploits out of this forum so far!
  10. Yes I suppose I could mask some blue paper roll down, that’ll give an indication. I do regularly check the bilge and it’s always dry.
  11. My bilge lowest point is just below my sump. It’s easily visible and dry.
  12. Thanks, I do wipe clean after every operation. Hence the yellow tub of wipes!
  13. Ok, I’ll keep my eye on it. Thanks. I was starting to worry that my heat exchanger (that I cleaned this season) had a leak.
  14. So would you be if we stood and laughed at you!
  15. That’s what I was thinking, plus it’s made of plastic so won’t hold up to pressure. But, it does have a min and max measurement. If I fill to max then go out , when I get back it’s on minimum. Well has done for the past two trips.
  16. Was that a technical catch or more of a kidnapping?
  17. This is the turbo in question, there were a couple of coolant pipes attached that I had to drain so yeah I guess it’s water cooled. And this is the bottle and cap
  18. It was explained to me that the bottle was an overflow tank. There is no pressure in it because it’s not sealed, it has a push top lid but that lid is just pop off pop on tight not screw on. I always fill from the top of the engine, like you would on a car, unscrew the cap and poor the coolant in. Could it be that there is air circulating that once finds its way out, it sucks some more coolant in? I’ve noticed a drop in level ever since I re fitted the turbo.
×
×
  • Create New...